Set Lighting Tricks Home
(FORWARDED)
Home Lighting Concept Design in 2011
Adjust the lighting in the home are things to think about. Because with the correct and optimal lighting will make all the activities we do in the house to be comfortable. To be able to make a light in the house to be optimal and in accordance with the needs of course there is the trick, and here’s a trick you can do.
Replace halogen MR16 by LED MR16
New Home
Replace fluorescent downlight by LED Downlight
Lighting with Very Good Lighting Design
Beautiful Home
Replace E27 incandescent by LED E27
Lighting with Fresh Home Art
2011 Home Lighting Concept Artistic
Nice Home Lighting Art Design for 2012
Replace fluorescent tube by LED Tube
Meet the needs of the primary light
In each room would require lighting. And the lighting was attempted whenever possible in order to illuminate the whole room evenly. It is intended to assist residents in performing all sorts of activities. It required an unnecessary lighting is too bright, but not enough to make the room too dark. Usually used to get the lamp type downlight illumination across the entire room.
Determine the activities that require more light
Try your analysis about the area where you normally use to perform specific activities in which if need more lighting. For example the kitchen, we need more lighting when we do cooking activities such as cutting or anything else that needs precision, or other areas that usually also require more lighting of the bedroom, usually we need to read, ornate, or even learn. Well after we know which areas require more lighting then we can provide local lighting or task lighting that leads to where we are running the event.
Utilizing dimmer
Dimmers are a tool used to vary the brightness of light. By utilizing the dimmer, then we can adjust the level of light overcast condition as we want. For example in the bedroom space, when we awake we may need a bright light, but while we’re sleeping we want a rather dim light. For that we can use a dimmer on a light table lamp downlights or placed on the nightstand.
Provide a night light
At night, for certain rooms should be given a rather dim lights that point to avoid the chamber into darkness so that it becomes difficult or dangerous to the pass. For example the area to the toilet or on the stairs.
Spread the light point
Rays originating from only one point will spread in all directions. As a result, the shadow will appear in all directions. Such a room must be very uncomfortable. Preferably in a space large enough (more than 6 mx 6 m) using more than one light source. If it is difficult holding more than one light source, it is better if you make it a point light beam branched into several points.
Trying indirect lighting
Ray sources, ie, the bulb should not be seen directly. That looks just the light or reflection or through intermediaries pendarannya frosted glass lampshades or other media that are cast rays. It is certainly costly in terms of the brightness level lights. But the rays are seen directly in the room sometimes very disturbing comfort and less eye-catching because of the light becomes very uneven penyinarannya in a space.
In regulating the lighting of course there is prohibition, namely:
- Create dazzling lighting. If the lamp used to use large wattage can definitely cause glare. In addition it can also be caused due to glare of white light and bounces on a white field. Therefore, we recommend if the white walls in the house do not directly lead to the wall lighting.
- Using one switch for many lights. You could use a lot of lights in one room, but try not to use a single switch, try to at most one switch to operate the four fruit lamp. If more than that, can cause energy waste due to unused lights will come on.
- Using a light house that is not appropriate. This causes the light effects are supposed to look good will be bad because it was blocked by the size of the lamp that is too big.
